3d_print_water_jet_cleaning_station
This is an old revision of the document!
Table of Contents
3D print water jet cleaning station
Supervisor | Tool Lead |
Brian Dincau | “WW Name” |
(###) ### #### | |
workshop-manager@cnsi.ucsb.edu | “WW Email” |
Description: “Waterjet Cleaner” |
Manufacturer: “Stratasys ” |
About
This waterjet cleaner is mainly used to clean the support material off Objet prints. Parts should typically be scraped clean with the waterjet cleaner only used to remove material in hard to reach areas and micropores within the RGD 450.
Training
Detailed Specifications
- Water consumption: less then 12 L/min
- 85-88 dB when operating
Safety Concerns
- Lid should remain latched and closed whenever the machine is on
- Water should be shut off to the machine imminently after cleaning is finished to avoid accidental flooding
- Cracked protective gloves should imminently be replaced
- Do not operate water jet outside of sealed container
Reference Documentation
3d_print_water_jet_cleaning_station.1672796520.txt.gz · Last modified: 2023/01/04 01:42 by bassari