This is an old revision of the document!
Table of Contents
Laurell WS-650M Spin Coater
Laurell WS-650M Spin Coater |
---|
Tool Type: Spin Coater |
Location: Elings 3430 |
Supervisor | Tool Lead |
David Bothman | “WW Name” |
(805) 893-4125 | (###) ###-#### |
bothman@cnsi.ucsb.edu | “WW Email” |
Description: Spin coater for applying thin coatings of PDMS and other resins |
Manufacturer: Laurell |
About
Insert Text Here!
Detailed Specifications
Insert Text Here!
Safety Concerns
Insert Text Here!
Operating Procedures
Training required for independent operation
1) Reserve this tool through FBS under “PDMS Tools”
2) When you arrive, ensure that CDA and vacuum are functional and that the spin-coater bowl is lined with paper towels.
3) Program or select your desired recipe (Steps, Spin Speed, Acceleration, Spin Time) and an appropriate chuck adapter, if needed.
4) Place your substrate, centered, on the chuck and then press the 'Vacuum' button.
5) Dispense your resin onto your substrate, try to use as little as necessary for a uniform coating.
6) Close the lid, then run your recipe.
7) When the recipe is complete, open the lid, turn off the vacuum by pressing the 'Vacuum' button again, and retrieve your coated substrate.
8) Repeat for as many samples as required.
9) When finished, if paper towel liners are very dirty, please replace them. Thank you!