ultimaker_3_quick_review
This is an old revision of the document!
Table of Contents
Ultimaker 3 Extended
last updated: 8/18 By: Furst
Safety Concerns
- Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time.
- Keep hands clear of printer during operation. Pause print before clearing or adjusting print.
Safe Operating Procedures Review
- Launch Cura version 4 (blue icon)
- From connected printers, select IW-Ultimaker3
- Select File → Open Files → Open desired project (.STL file type)
- Using task bar on the left hand side, position model as desired
- From print settings, select slice height, infill percentage, and support
- Support can be generated using ether nozzle, typically nozzle one holds build material with nozzle two printing with dissolvable support material.
- Setting can be fined tuned using the “Custom” option from print settings
- Within custom settings, nozzle and build plate temps can be adjusted (build plate temps should be based off of build material)
- Save the file from Cura on a thumb drive
- Connect thumb drive to printer → select desired file → select print
Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired.
Post Processing
- If support was used carefully remove support structure if
—–
ultimaker_3_quick_review.1597773569.txt.gz · Last modified: 2020/08/18 17:59 by furst