Differences

This shows you the differences between two versions of the page.

--- ww_resources [2023/05/31 21:03] – [CNSI Labs Training Process Outline] haley
+++ ww_resources [2024/01/22 18:46] (current) – [Workshop Wizard Handbook] bdincau
@@ Line 12: / Line 12: @@
 Use the [[https://gateway.procurement.ucsb.edu/|Gateway]] portal to make purchasing procurements and assign carts to lab managers and PI's. Instructions on how to use Gateway for a variety of suppliers can be found [[gateway instructions|here]].
+Please use the [[https://docs.google.com/spreadsheets/d/1tsk33REldSCG_K3IUdnO2trJ6KU5xylbnU2aOj1NPgU/edit#gid=0 | Projects Spreadsheet]] to sign up for and track ongoing internal jobs.
 === Training ===
@@ Line 51: / Line 53: @@
+=== Maintenance ===
+__Lens and Mirror Cleaning__
+Printer Lens and Mirrors must be cleaned weekly to remove the buildup of dirt and dust and prolong the life of the lens and mirror. There are two mirrors however mirror #2 requires removing the right side maintenance panel and should only be cleaned by IW staff. Always check Lens cleaning log before printing and ensure the lens was cleaned at least 2 weeks before. To clean the lens and Mirror #1:
+  - Ensure Laser cutter is off
+  - Wearing Nitrile gloves, remove the lens from the head with cloth/bubble wrap underneath incase lens is dropped.
+  - Blow off any dust from lens with compressed air
+  - Wipe lens once with lens cleaning solution and lens wipes found in the Laser cutter bin
+  - Put a drop of lens cleaning solution on lens and let sit for a minute before wiping off
+  - Repeat with other side of lens
+  - Replace the lens in the correct orientation with concave side pointing up.
+  - Remove the mirror using the set screws and clean in the same fashion as the lens. Replace mirror
+  - Log the cleaning of the lens and any additional notes such as condition of the lens in the lens cleaning log
+__Particulate Filter Change for Atmos Compact__
+  - Turn off the Atmos and unplug the main.
+  - Open the filter housing, the black drawer will be seen on the left.
+  - Unplug the measurement hose (connected to the front of the drawer) and carefully pull the drawer out of the housing.
+  - Unscrew the front of the drawer, this area is the activated carbon housing.
+  - Remove the activated carbon and the filter mats (located on the sides) into a disposable bag.
+  - Place the new mats in, noting that the blue imprints should face the exterior of the drawer.
+  - Pour in a limited amount of activated carbon. If the mats stay in position, proceed to fill the container with activated carbon.
+  - Close the chamber with the fasteners.
+  - Slide the drawer back into the filter housing. Make sure that the filter is sitting firmly and is attached airtight to the back of the housing.
+  - To reset the error signal, press “+” and ”-” on the control panel consecutively for 3 seconds. The LED should then read “Activated Carbon OK.”
+Note the following when conducting maintenance on the Atmos:
+  * All waste from the compact must be labeled as hazardous before disposal.
+  * A more detailed list of all the error commands on the exhaust system can be found on page 40 of the manual (linked at the beginning of the SOP).