trimsaw2sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
trimsaw2sop [2020/11/03 17:45] – furst | trimsaw2sop [2020/11/03 17:46] (current) – furst | ||
---|---|---|---|
Line 159: | Line 159: | ||
* Carefully remove the blade from its arbor and replace with the blade matching the material you intend to cut | * Carefully remove the blade from its arbor and replace with the blade matching the material you intend to cut | ||
* Lightly LUBRICATE the threads on the end of the blade arbor with a grease to prevent thread galling. | * Lightly LUBRICATE the threads on the end of the blade arbor with a grease to prevent thread galling. | ||
- | * Tighten the blade retaining nut HAND TIGHT (no need to go crazy on this one down) | + | * Tighten the blade retaining nut HAND TIGHT (no need to go crazy on this) |
* Insure the coolant level is in contact with the bottom of the blade and filled to the fill line | * Insure the coolant level is in contact with the bottom of the blade and filled to the fill line | ||
trimsaw2sop.1604425542.txt.gz · Last modified: 2020/11/03 17:45 by furst