trimsaw2sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
trimsaw2sop [2020/11/03 17:45] – furst | trimsaw2sop [2020/11/03 17:46] (current) – furst | ||
---|---|---|---|
Line 82: | Line 82: | ||
* Replace the table | * Replace the table | ||
- | ====Blade Selection | + | ====Blade Selection==== |
* CBN Bond blades are used for cutting ferrous metals. Metal bond blades <1,000 RPM, Resin bond blades >1000 RPM | * CBN Bond blades are used for cutting ferrous metals. Metal bond blades <1,000 RPM, Resin bond blades >1000 RPM | ||
* Diamond Metal Bond blades: high concentration blades for general use at high or low speeds, low concentration blades for ceramics, Silicon, glass. Cut at low speed ,1,000 RPM | * Diamond Metal Bond blades: high concentration blades for general use at high or low speeds, low concentration blades for ceramics, Silicon, glass. Cut at low speed ,1,000 RPM | ||
Line 159: | Line 159: | ||
* Carefully remove the blade from its arbor and replace with the blade matching the material you intend to cut | * Carefully remove the blade from its arbor and replace with the blade matching the material you intend to cut | ||
* Lightly LUBRICATE the threads on the end of the blade arbor with a grease to prevent thread galling. | * Lightly LUBRICATE the threads on the end of the blade arbor with a grease to prevent thread galling. | ||
- | * Tighten the blade retaining nut HAND TIGHT (no need to go crazy on this one down) | + | * Tighten the blade retaining nut HAND TIGHT (no need to go crazy on this) |
* Insure the coolant level is in contact with the bottom of the blade and filled to the fill line | * Insure the coolant level is in contact with the bottom of the blade and filled to the fill line | ||
trimsaw2sop.1604425526.txt.gz · Last modified: 2020/11/03 17:45 by furst