sherline_training_sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
sherline_training_sop [2022/10/05 22:16] – furst | sherline_training_sop [2022/10/05 22:18] (current) – furst | ||
---|---|---|---|
Line 2: | Line 2: | ||
Last edited: Furst (08/26/20) | Last edited: Furst (08/26/20) | ||
- | Instructor: \\ | ||
- | |||
- | Date: \\ | ||
- | {| style="" | ||
- | |+ Attendees: | ||
- | ! | ||
- | |||
- | ! | ||
- | Name | ||
- | ! | ||
- | Group or Company | ||
- | ! | ||
- | Signature | ||
- | |- | ||
- | |1 | ||
- | | | ||
- | | | ||
- | | | ||
- | |- | ||
- | |2 | ||
- | | | ||
- | | | ||
- | | | ||
- | |- | ||
- | |3 | ||
- | | | ||
- | | | ||
- | | | ||
- | |- | ||
- | |4 | ||
- | | | ||
- | | | ||
- | | | ||
- | |- | ||
- | |5 | ||
- | | | ||
- | | | ||
- | | | ||
- | |- | ||
- | |6 | ||
- | | | ||
- | | | ||
- | | | ||
- | |} | ||
====Overview: | ====Overview: | ||
Line 69: | Line 25: | ||
====Applications==== | ====Applications==== | ||
- | The Sherline CNC is used exclusively for for drilling holes in glass, ceramic, silicon, | + | The Sherline CNC is used exclusively for for drilling holes in glass, ceramic, silicon, |
Typical applications include adding macro to micro interface connecters to Microfluidics chips. | Typical applications include adding macro to micro interface connecters to Microfluidics chips. | ||
====Software==== | ====Software==== | ||
- | The Sherline CNC uses a retrofitted | + | The Sherline CNC uses a retrofit |
FlashCut CNC offers a user interface for positioning, | FlashCut CNC offers a user interface for positioning, | ||
====Sample Prep==== | ====Sample Prep==== | ||
- | A backing plate is required for drilling, and should be bonded to the substrate to be drilled to improve backside cut quality. If bonding is not permitted, slowing down cut speed may result in less blowout on the backside of the hole. | + | A backing plate is required for drilling, and should be bonded to the substrate to be drilled to improve backside cut quality |
- set CrystalBond hotplate to 121 degrees C | - set CrystalBond hotplate to 121 degrees C | ||
- place a sheet of tinfoil or wax paper over hotplate to avoid spilling of crystal bond | - place a sheet of tinfoil or wax paper over hotplate to avoid spilling of crystal bond |
sherline_training_sop.1665008174.txt.gz · Last modified: 2022/10/05 22:16 by furst