Differences

This shows you the differences between two versions of the page.

--- miter_saw_sop [2020/12/04 19:15] – furst
+++ miter_saw_sop [2020/12/21 01:19] (current) – furst
@@ Line 88: / Line 88: @@
 ====Saw Setup====
 The Miter saw is designed to be plugged into the Festool dust collector. By setting the dust collector to auto and hooking up the dust collection hose, the dust collector will automatically turn on when the making a cut.
-\\
+\\ {{:tools:mitersaw:img_5898.jpg?400|}}
 **Setting up the saw**
   - Adjusting blade tilt
-    - Rotate knob protruding from the right overarm to tilt the head assembly and blade
+    - Rotate knob protruding from the right overarm to tilt the head assembly and blade \\ {{:tools:mitersaw:img_5900.jpg?400|}}
-  - Adjusting fence rotation
+  - Adjusting fence rotation \\ {{:tools:mitersaw:img_5899.jpg?400|}}
     - Lift the lower lever protruding from the front of the blade guide to release the brake
     - Depress the smaller thumb lever above the brake lever to allow the fence to rotate
@@ Line 100: / Line 100: @@
 **Securing the workpiece**
-  - Pull the green head lock lever to raise the saw head and blade
+  - Pull the green head lock lever to raise the saw head and blade \\ {{:tools:mitersaw:img_5901.jpg?400|}}
   - Position the workpiece pressed firmly against the fence making sure it is supported on both ends if overhanging the saw body
   - The fence can be adjusted slightly if necessary
@@ Line 124: / Line 124: @@
 ====Maintenance====
-**Changing Blades**
+**Changing Blades** \\ {{:tools:mitersaw:img_5903.jpg?400|}}
   - Unplug the saw and unhook any vacuum attachment
   - Loosen the plastic protective guide blocking the saw arbor screw (3mm)