mini_drill_press
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mini_drill_press [2023/01/06 00:11] – haley | mini_drill_press [2023/01/06 01:30] (current) – [Mini Drill Press] haley | ||
---|---|---|---|
Line 12: | Line 12: | ||
| **Manufacturer: | | **Manufacturer: | ||
+ | 1/5/23 Haley | ||
---- | ---- | ||
Line 30: | Line 31: | ||
===== Operating Procedures ===== | ===== Operating Procedures ===== | ||
- | --- | + | - Layout and center punch the holes you wish to drill |
+ | - Insert drill bit into the drill chuck, tighten with the chuck key, and remove the chuck key before continuing. Note: Do not tighten the chuck by powering on the machine and do not leave the chuck key in the chuck. These are both extremely dangerous and unsafe practices. | ||
+ | - Align the holes with the drill bit and secure the part using the vice or the drill bed clamp. | ||
+ | - Adjust the work table to the appropriate height and lock securely. | ||
+ | - Check that the tool can spin freely and that it is clear of the part. | ||
+ | - Determine the proper feed rate and speed rate for the given hole/ | ||
+ | - Apply cutting lubricant to the part | ||
+ | - Turn the machine on | ||
+ | - Use peck drilling operations to drill the hole, remove material in 0.05 inch increments. | ||
+ | - Remove chips and swarf using a brush. Do not use a rag or your bare hands to remove chips. | ||
+ | - Apply additional cutting fluid as necessary throughout the operation | ||
+ | - Reduce pressure when breaking through to prevent damage to the tool and part. Use backing board to prevent the part from blowing out. | ||
+ | - Power down the machine when done. Do not attempt to slow the machine down by hand. | ||
+ | - Use a brush and/or rag to clean up any chips, shavings, and oil from the drill press and the surrounding areas. | ||
+ | - Return all tools to their proper location and power down the drill press. Tidy up the work area. | ||
+ | |||
+ | ---- | ||
===== Detailed Specifications ===== | ===== Detailed Specifications ===== |
mini_drill_press.1672963896.txt.gz · Last modified: 2023/01/06 00:11 by haley