Differences

This shows you the differences between two versions of the page.

--- laser_cutter_training_sop [2023/07/17 22:55] – rylin
+++ laser_cutter_training_sop [2023/09/12 22:01] (current) – [Material] bdincau
@@ Line 1: / Line 1: @@
 =====CNSI Innovation Workshop and Microfluidics Lab Trotec Speedy100 Safe Operating Procedures=====
-Last Updated: 5/31/23 Haley \\
+Last Updated: 7/17/23 Rachel \\
 This SOP is compiled from the following sources. For more information reference these sources.
   * [[https://www.troteclaser.com/fileadmin/content/images/Contact_Support/Manuals/8010-Speedy-100-Manual-EN.pdf|Trotec Speedy Manual]]
@@ Line 61: / Line 61: @@
   * ABS (acrylonitrile butadiene styrene)
   * Acrylic (also known as Plexiglas, Lucite, PMMA)
-  * Delrin (POM, acetal) — for a supplier, try www.mcmaster.com.
+  * Delrin (POM, acetal) — **Must use nitrogen assist when cutting delrin**
   * Kapton tape (Polyimide)
   * Mylar (polyester)
@@ Line 165: / Line 165: @@
 |}
-====Functional Engraving Recipes====
+====General Kerf Width For Acrylic====
-For users looking to cut acrylic at different depths, different cut depths were tested with different power settings.
-{| style=""
-|+
-!
-Engraving Settings
-!
-Engraving Cut Thickness
-|-
-|
-mm
-|
-% power, 0% speed
-|-
-|
-.208 mm
-|
-% power, 30% speed
-|-
-|
-.314 mm
-|
-% power, 30% speed
-|-
-|
-.352 mm
-|
-% power, 30% speed
-|-
-|
-.413 mm
-|
-% power, 30% speed
-|-
-|
-.446 mm
-|
-% power, 30% speed
-|-
-|
-.485 mm
-|
-% power, 30% speed
-|}
-====General Curf Width For Acrylic====
 {| style=""
 |+
@@ Line 217: / Line 171: @@
 Thickness
 !
-Curf Width
+Kerf Width
 |-
 |