User Tools

Site Tools


laser_cutter_training_sop

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
laser_cutter_training_sop [2023/05/31 21:05] haleylaser_cutter_training_sop [2023/09/12 22:01] (current) – [Material] bdincau
Line 1: Line 1:
 =====CNSI Innovation Workshop and Microfluidics Lab Trotec Speedy100 ​Safe Operating Procedures=====  =====CNSI Innovation Workshop and Microfluidics Lab Trotec Speedy100 ​Safe Operating Procedures===== 
-Last Updated: 5/31/23 Haley \\+Last Updated: 7/17/23 Rachel \\
 This SOP is compiled from the following sources. For more information reference these sources. This SOP is compiled from the following sources. For more information reference these sources.
   * [[https://www.troteclaser.com/fileadmin/content/images/Contact_Support/Manuals/8010-Speedy-100-Manual-EN.pdf|Trotec Speedy Manual]]   * [[https://www.troteclaser.com/fileadmin/content/images/Contact_Support/Manuals/8010-Speedy-100-Manual-EN.pdf|Trotec Speedy Manual]]
Line 61: Line 61:
   * ABS (acrylonitrile butadiene styrene)   * ABS (acrylonitrile butadiene styrene)
   * Acrylic (also known as Plexiglas, Lucite, PMMA)   * Acrylic (also known as Plexiglas, Lucite, PMMA)
-  * Delrin (POM, acetal) — for a supplier, try www.mcmaster.com.+  * Delrin (POM, acetal) — **Must use nitrogen assist when cutting delrin**
   * Kapton tape (Polyimide)   * Kapton tape (Polyimide)
   * Mylar (polyester)   * Mylar (polyester)
Line 165: Line 165:
 |} |}
  
-====General Curf Width For Acrylic====+====General Kerf Width For Acrylic====
 {| style="" {| style=""
 |+ |+
Line 171: Line 171:
 Thickness Thickness
 ! !
-Curf Width+Kerf Width
 |- |-
 | |
laser_cutter_training_sop.1685567113.txt.gz · Last modified: 2023/05/31 21:05 by haley