haas_super_mini_mill_training_sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
haas_super_mini_mill_training_sop [2021/03/11 19:53] – furst | haas_super_mini_mill_training_sop [2023/01/05 02:36] (current) – [Haas Super Mini Mill Training SOP] haley | ||
---|---|---|---|
Line 1: | Line 1: | ||
======Haas Super Mini Mill Training SOP====== | ======Haas Super Mini Mill Training SOP====== | ||
- | Last edited: Furst (09/28/20) | + | Last edited |
Instructor: \\ | Instructor: \\ | ||
Line 145: | Line 145: | ||
* The spindle must be completely stopped before adjusting or removing work piece | * The spindle must be completely stopped before adjusting or removing work piece | ||
* After milling is completed, the work piece will have developed sharp burrs which must be removed with a hand file or sandpaper | * After milling is completed, the work piece will have developed sharp burrs which must be removed with a hand file or sandpaper | ||
- | ====Safe Operating Procedures Review==== | + | ===== Operating Procedures Review |
- | - Design part using Solidworks or other CAD platform | + | - Program tool paths using a SOLIDWORKS add-in |
- | - Using HSM Works generate | + | - Put tools in tool holders |
- | - Each different | + | - Set tool offsets using tool probe |
- | - Use 2D and 3D clearing and pocketing to remove | + | - Set fixture offset(s) with touch probe (usually G54) |
- | - Simulate | + | - Load program |
- | - Using the open ended wrench on the spindle flats and the spanner on the collet nut to change out the tool or collet itself if switching shank diameter | + | - Check that tool numbers in program match tools in machine |
- | - Home the machine and zero the tool using Shopbot 3, set part zero using the yellow keypad and slowly jogging the tool or edge finder | + | - Check that appropriate fixture offset is loaded |
- | - Upload | + | - Load stock in the machine |
- | - Start program | + | - Proof the part (test the program with air cuts). One easy way to do this is to add a height to the G54 Z value sufficient |
+ | - Use rapid and feed override at the beginning of the program | ||
+ | - Keep your hand close to the emergency stop in case the program doesn’t do what you expect. | ||
+ | - Reset G54 to the correct value. | ||
+ | - Run the program | ||
====Post Processing==== | ====Post Processing==== |
haas_super_mini_mill_training_sop.1615492381.txt.gz · Last modified: 2021/03/11 19:53 by furst