formwash_cleaner
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
formwash_cleaner [2020/07/09 17:52] – created furst | formwash_cleaner [2023/07/12 17:06] (current) – rylin | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
- | + | ||
- | ^ Form Wash Cleaner^ | + | ^ FormWash |
| {{: | | {{: | ||
- | | **Tool Type: | + | | **Tool Type: |
- | | **Location: | + | | **Location: |
- | | **Supervisor** | + | | **Description: |
- | | David Bothman | + | | **Manufacturer: |
- | | (805) 893-4125 | + | |
- | | bothman@cnsi.ucsb.edu | + | |
- | + | ||
- | | **Description: | + | |
- | | **Manufacturer: | + | |
+ | Last updated 1/5/23 Haley | ||
---- | ---- | ||
===== About ===== | ===== About ===== | ||
- | The Form Wash is a post processor for the Form 2 resin 3D printers. Using an alcohol bath, build trays and/or parts can be loaded into the Form Wash where all uncured resin from the surface of the prints is removed. | + | The FormWash |
---- | ---- | ||
- | ===== Detailed Specifications | + | ===== Safety Concerns |
- | Insert Text Here! | + | FormWash contains large amounts of IPA, a flammable solvent. Keep away from any possible sources of heat or sparks. Filling the FormWash should only be done by a Workshop Wizard within the fume hood. |
---- | ---- | ||
- | ===== Safety Concerns | + | ===== Operating Procedures |
+ | - Remove build platform from Form 2 3D printer, making sure to keep Tupperware under print to prevent drips | ||
+ | - Wake the Form Wash using the large dial located bottom right of the front face, select " | ||
+ | - Load the build platform or optionally remove prints from build platform and load into Form Wash basket. | ||
+ | - Using the dial select the desired amount of time, click " | ||
+ | - When the wash is complete, Remove parts and/or build tray, and select " | ||
+ | NOTE: When the Form Wash in complete, the lid will automatically open, allowing alcohol to evaporate. Before leaving, make sure Form Wash is shut. DO NOT LEAVE AFTER STARTING FORM WASH!!! | ||
+ | ---- | ||
- | Insert Text Here! | ||
- | ---- | + | ===== Detailed Specifications |
- | + | ||
- | ===== Operating Procedures | + | |
- | Insert Text Here! | + | * Max part size: 14.5 x 14.5 x 17.5 cm |
+ | * 8.6 L IPA to fill completely | ||
---- | ---- | ||
===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
+ | [[form2sop|Form 2 Training SOP]] | ||
+ | [[https:// | ||
- | ---- | + | [[https:// |
- | ===== Training Documentation ===== | + | |
- | Insert Text Here! | ||
---- | ---- | ||
+ |
formwash_cleaner.1594317168.txt.gz · Last modified: 2020/07/09 17:52 by furst