formcure_uv
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
formcure_uv [2023/01/06 00:41] – [FormCure UV Curing Station] haley | formcure_uv [2023/01/06 00:41] – haley | ||
---|---|---|---|
Line 18: | Line 18: | ||
After your FormLabs print has gone through the FormWash, the resin should be cured in the FormCure, a UV curing chamber. Each resin has a specific hardening curve that can be found within the reference material. This will help you indicate the ideal time and temperature to be set on the FormCure. | After your FormLabs print has gone through the FormWash, the resin should be cured in the FormCure, a UV curing chamber. Each resin has a specific hardening curve that can be found within the reference material. This will help you indicate the ideal time and temperature to be set on the FormCure. | ||
- | |||
- | ---- | ||
- | |||
- | ===== Detailed Specifications ===== | ||
- | * Max cure temp: 80 degrees C | ||
- | * Light: 39W total drawn by 13 405 nm LEDs | ||
- | |||
---- | ---- | ||
Line 45: | Line 38: | ||
----- | ----- | ||
+ | |||
+ | ===== Detailed Specifications ===== | ||
+ | * Max cure temp: 80 degrees C | ||
+ | * Light: 39W total drawn by 13 405 nm LEDs | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
+ | |||
+ | [[form2sop|Form 2 Training SOP]] | ||
+ | |||
[[https:// | [[https:// | ||
Line 57: | Line 61: | ||
- | ===== Training Documentation ===== | + | |
- | [[form2sop|Form 2 Training SOP]] | + | |
- | ---- | + |
formcure_uv.txt · Last modified: 2023/01/06 00:43 by haley