Differences

This shows you the differences between two versions of the page.

--- crystalmarksop [2023/12/01 01:02] – [Safe Operating Procedures Review] colin
+++ crystalmarksop [2024/01/22 17:54] (current) – [Rates] bdincau
@@ Line 52: / Line 52: @@
   - "Set" -> "Zero X", "Set" -> "Zero Y"
   - Note that origin is displayed in "DXF to G-Code Converter" (You can modify the origin in the software your .dxf was created): \\ {{:dxfzero.jpg?direct&200|}}
+  - Use tape and/or turn on vaccum to fixture part (optional)
   - Begin etching : "G-Code" -> "Start"
   - Monitor operation
@@ Line 92: / Line 93: @@
 If the Crystalmark is not cutting, the abrasive canister may be empty. Please
 contact workshop staff to refill tool.
-====Rates====
-CrystalMark:
-$ 24.30	Hour (Internal and External Rate)