crystalmarksop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
crystalmarksop [2023/12/01 01:02] – [Safe Operating Procedures Review] colin | crystalmarksop [2024/01/22 17:54] (current) – [Rates] bdincau | ||
---|---|---|---|
Line 52: | Line 52: | ||
- " | - " | ||
- Note that origin is displayed in "DXF to G-Code Converter" | - Note that origin is displayed in "DXF to G-Code Converter" | ||
+ | - Use tape and/or turn on vaccum to fixture part (optional) | ||
- Begin etching : " | - Begin etching : " | ||
- Monitor operation | - Monitor operation | ||
Line 92: | Line 93: | ||
If the Crystalmark is not cutting, the abrasive canister may be empty. Please | If the Crystalmark is not cutting, the abrasive canister may be empty. Please | ||
contact workshop staff to refill tool. | contact workshop staff to refill tool. | ||
- | ====Rates==== | + | |
- | CrystalMark: | + | |
- | $ 24.30 Hour (Internal and External Rate) | + |
crystalmarksop.txt · Last modified: 2024/01/22 17:54 by bdincau