Differences

This shows you the differences between two versions of the page.

--- carbide_3d_nomad_883_training_sop [2020/09/08 20:01] – [Choosing tools] furst
+++ carbide_3d_nomad_883_training_sop [2020/09/08 20:12] – furst
@@ Line 147: / Line 147: @@
   * After milling is completed, the work piece will have developed sharp burrs which must be removed with a hand file or sandpaper
 ====Safe Operating Procedures Review====
-  - Launch Cura version 4 (blue icon)
+  - Design part using Solidworks or other CAD platform
-  - From connected printers, select IW-Ultimaker3
+  - Using HSM Works or Carbide Create generate tool paths
-  - Select File -> Open Files -> Open desired project (.STL file type)
+    - Each different tool needs to be a separate job as only one tool can be loaded into the Carbide at a time
-  - Using task bar on the left hand side, position model as desired
+    - Use 2D and 3D clearing and pocketing to remove the bulk of the material while using "stock to leave" to allow for a finishing pass
-  - From print settings, select slice height, infill percentage, and support
+    - Simulate the toolpaths to verify that the tool will not crash and is cutting in the desired location
-  - Support can be generated using ether nozzle, typically nozzle one holds build material with nozzle two printing with dissolvable support material.
+  - Using the 17 and 11 mm wrenches loosen the collet nut to change out the tool or collet itself if switching shank diameter
-  - Setting can be fined tuned using the "Custom" option from print settings
+  - Home the machine and zero the tool using Carbide Motion under the "jog" heading
-  - Within custom settings, nozzle and build plate temps can be adjusted (build plate temps should be based off of build material)
+  - Upload the G-Code into Carbide Motion under "load"
-  - Save the file from Cura on a thumb drive
+  - Start program
-  - Connect thumb drive to printer -> select desired file -> select print\\
-Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired.
 ====Post Processing====
-  * If support was constructed from ABS carefully break away with pliers
+  * Use a file to debur the part
-  * If support was constructed from PVA soak part in warm water for several hours to dissolve support structure
 ====Maintenance====
   * Tools should be wiped clear of chips or coolant using an acid brush