Differences

This shows you the differences between two versions of the page.

--- 3d_print_water_jet_cleaning_station [2023/01/06 00:34] – [Operating Procedures] haley
+++ 3d_print_water_jet_cleaning_station [2023/07/12 17:05] (current) – rylin
@@ Line 1: / Line 1: @@
-====== 3D print water jet cleaning station ======
+====== 3D Print Water Jet Cleaning Station ======
@@ Line 10: / Line 10: @@
-| **Description:**                Presssure washer                  |
+| **Description:**                Pressure washer                  |
 | **Manufacturer:**               Stratasys                          |
@@ Line 33: / Line 33: @@
   - Place part within the pressure washer and open the DI valve on the sink. The power switch is located on the back of the washing enclosure.
   - Using the foot pedal, clean the part using the high pressure nozzles located within the enclosure
-  - After part has been cleaned, **ensure the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment
+  - After part has been cleaned, **ensure that the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment
   - To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours
+----
 ===== Detailed Specifications =====
   * Water consumption: less then 12 L/min