Differences

This shows you the differences between two versions of the page.

--- 3d_print_water_jet_cleaning_station [2023/01/06 00:31] – haley
+++ 3d_print_water_jet_cleaning_station [2023/07/12 17:05] (current) – rylin
@@ Line 1: / Line 1: @@
-====== 3D print water jet cleaning station ======
+====== 3D Print Water Jet Cleaning Station ======
@@ Line 10: / Line 10: @@
-| **Description:**                Presssure washer                  |
+| **Description:**                Pressure washer                  |
 | **Manufacturer:**               Stratasys                          |
@@ Line 30: / Line 30: @@
 ===== Operating Procedures =====
+  - First remove the bulk of the Objet support material (FullCure705) with the cleaning implements found next to the pressure washer. Wear gloves as uncured resin may be on the surface of the part.
+  - Place part within the pressure washer and open the DI valve on the sink. The power switch is located on the back of the washing enclosure.
+  - Using the foot pedal, clean the part using the high pressure nozzles located within the enclosure
+  - After part has been cleaned, **ensure that the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment
+  - To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours
 ----
 ===== Detailed Specifications =====
   * Water consumption: less then 12 L/min