Differences

This shows you the differences between two versions of the page.

--- 3d_print_water_jet_cleaning_station [2023/01/04 23:52] – [Training] haley
+++ 3d_print_water_jet_cleaning_station [2023/07/12 17:05] (current) – rylin
@@ Line 1: / Line 1: @@
-====== 3D print water jet cleaning station ======
+====== 3D Print Water Jet Cleaning Station ======
 ^                PolyJet Waterjet             ^
 |                                 {{:tools:polyjet_waterjet:download.jpg?200|}}                                      |
-| **Tool Type:**                  Post processing/Cleaning                 |
+| **Tool Type:**                  Post-processing                |
 | **Location:**                   Microfluidics Lab                          |
-|  **Supervisor**        |  **Tool Lead**  |
-|  Brian Dincau         |  "WW Name"  |
-|          |  (###) ### ####  |
-|  workshop-manager@cnsi.ucsb.edu	  |  "WW Email"  |
-| **Description:**                This tool removes support material from parts 3D printed by the Objet 30.                  |
+| **Description:**                Pressure washer                  |
 | **Manufacturer:**               Stratasys                          |
+Last updated 1/5/23 Haley
 ----
 ===== About =====
-This waterjet cleaner is mainly used to clean the support material off Objet prints. Parts should typically be scraped clean with the waterjet cleaner only used to remove material in hard to reach areas and micropores within the RGD 450.
+This tool removes support material from parts 3D printed by the Objet 30.
 ----
+===== Safety Concerns =====
+  * Lid should remain latched and closed whenever the machine is on
+  * Water should be shut off to the machine imminently after cleaning is finished to avoid accidental flooding
+  * Cracked protective gloves should imminently be replaced
+  * Do not operate water jet outside of sealed container
+----
+===== Operating Procedures =====
+  - First remove the bulk of the Objet support material (FullCure705) with the cleaning implements found next to the pressure washer. Wear gloves as uncured resin may be on the surface of the part.
+  - Place part within the pressure washer and open the DI valve on the sink. The power switch is located on the back of the washing enclosure.
+  - Using the foot pedal, clean the part using the high pressure nozzles located within the enclosure
+  - After part has been cleaned, **ensure that the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment
+  - To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours
+----
 ===== Detailed Specifications =====
   * Water consumption: less then 12 L/min
@@ Line 31: / Line 44: @@
 -----
-===== Safety Concerns =====
-  * Lid should remain latched and closed whenever the machine is on
-  * Water should be shut off to the machine imminently after cleaning is finished to avoid accidental flooding
-  * Cracked protective gloves should imminently be replaced
-  * Do not operate water jet outside of sealed container
-----
 ===== Reference Documentation =====
+[[objet30trainingsop|Objet 30 Users Outline and SOP]]
 {{ :tools:polyjet_waterjet:objet_waterjet_installation_and_user_guide_-_english.pdf |}}