Differences

This shows you the differences between two versions of the page.

--- waterjetsop [2026/02/03 18:27] – [Troubleshooting] colin
+++ waterjetsop [2026/02/03 18:32] (current) – [Troubleshooting] colin
@@ Line 106: / Line 106: @@
 ====Troubleshooting====
-  * **Abrasive Clog**. If there are no cuts appearing after starting a job, it may be because the abrasive is clogged. Make sure there is abrasive coming out by removing the abrasive slip cover and then the dry abrasive hopper. Check to see if the plug hole has anything clogging it with a flashlight, and if there is, press the pinch valve button and clear it with compressed air. Press the pinch valve button again and if there is abrasive flowing through, the clog has been resolved. Refer to the dry hopper clearing procedures [the dry hopper clearing procedures[https://support.wazer.com/resources/maintenance/procedures/clearing-the-dry-abrasive-hopper]] for more details
+  * **Abrasive Clog**. If there are no cuts appearing after starting a job, it may be because the abrasive is clogged. Make sure there is abrasive coming out by removing the abrasive slip cover and then the dry abrasive hopper. Check to see if the plug hole has anything clogging it with a flashlight, and if there is, press the pinch valve button and clear it with compressed air. Press the pinch valve button again and if there is abrasive flowing through, the clog has been resolved. Refer to the [[ https://support.wazer.com/resources/maintenance/procedures/clearing-the-dry-abrasive-hopper | dry hopper clearing procedures]] for more details
   * **Continuous High-Pitched Noise**. The waterjet will produce a loud high-pitched noise when piercing at the beginning of each cut. If the noise does not decrease after the nozzle begins moving around, it is possible that the material was not fully pierced. Pause the operation and check, and restart if needed.
+  * **[[ https://support.wazer.com/resources/troubleshooting- | Wazer Troubleshooting]]**.
 -----