Differences

This shows you the differences between two versions of the page.

--- waterjetsop [2023/09/20 17:08] – yanis
+++ waterjetsop [2023/09/26 23:20] (current) – [Cutting with the Wazer Waterjet] bdincau
@@ Line 69: / Line 69: @@
     - Select your tabs and leads. This will prevent vibration/pop-ups, which will jam the waterjet and ruin the cut, and also improve accuracy.
       - Usually 2-4 tabs is enough for most materials and thicknesses.
-      - Tab thickness should be proportional to material thickness, a good rule of thumb is for your tab thickness to be 30-50% of your material thickness
+      - Tab thickness should be proportional to material thickness, a good rule of thumb is for your tab thickness to be 30-50% of your material thickness. For very thin materials, we recommend a minimum tab thickness of 0.05"
     - Select the cut quality. This will determine time for each job and the amount of abrasive used.
       - Fine usually gives the best results
@@ Line 79: / Line 79: @@
   - **Turn on Water and Power Supplies**.{{ :tools:wazer_waterjet:img-1580.jpg?200|}}
     - Turn the sink handle on, you should see the filter water pressure jump up. Ensure that the pressure gauge is in the green, if it's not there isn't enough water flow and you CANNOT CUT.
-      - If there are any signs of leaks, turn off the water immediately and notify a wizard. Make sure the power supplies have a green light on. If not, try pressing reset.
+      - If there are any signs of leaks, turn off the water immediately and notify a wizard.
     - Check that the drain hose is going into the sink.
     - Turn on the wazer and pump by pressing the "reset" button on the power blocks (bottom right and top left relative to the wazer).
@@ Line 100: / Line 100: @@
   - **YOU MUST NOT LEAVE WHILE PART IS BEING CUT**
   - Once the print has been completed, open the lid, unscrew your material, and remove the part. Beware of sharp edges. Make sure all pieces of material are removed from bed.
-  - **Tank Cleaning and Maintenance**. Run a tank cleaning cycle if you are not making another cut for a while or if the machine has been running for more than 4 hours. This will collect abrasive that is at the bottom of the tank. There will be some abrasive that accumulates from the door windows and on the bellows. If they are not coming off easily, let them dry and then sweep.
+  - **Turn off the printer**
-  - **Turn off the printer** and leave the lid open.
+    - Press test on both the power supplies.
+    - Close the sink lever and ensure that the pressure drops in the filter gauge (it won't go all the way down to to 0)
+    - Leave the wazer lid open.
 ====Troubleshooting====