laser_cutter_training_sop
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| laser_cutter_training_sop [2023/07/30 16:13] – colin | laser_cutter_training_sop [2024/09/30 20:03] (current) – kho | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | =====CNSI | + | =====CNSI Trotec Speedy100 Safe Operating Procedures===== |
| Last Updated: 7/17/23 Rachel \\ | Last Updated: 7/17/23 Rachel \\ | ||
| This SOP is compiled from the following sources. For more information reference these sources. | This SOP is compiled from the following sources. For more information reference these sources. | ||
| Line 18: | Line 18: | ||
| ====Location==== | ====Location==== | ||
| - | The Trotec Laser printer is located upstairs in the Microfluidics Lab next to the Haas CNC machine in the back of the room. | + | The Trotec Laser printer is located upstairs in Elings 3430 next to the Haas CNC machine in the back of the room. |
| ====Overview==== | ====Overview==== | ||
| Line 61: | Line 61: | ||
| * ABS (acrylonitrile butadiene styrene) | * ABS (acrylonitrile butadiene styrene) | ||
| * Acrylic (also known as Plexiglas, Lucite, PMMA) | * Acrylic (also known as Plexiglas, Lucite, PMMA) | ||
| - | * Delrin (POM, acetal) — for a supplier, try www.mcmaster.com. | + | * Delrin (POM, acetal) — **Must use nitrogen assist when cutting delrin** |
| * Kapton tape (Polyimide) | * Kapton tape (Polyimide) | ||
| * Mylar (polyester) | * Mylar (polyester) | ||
laser_cutter_training_sop.1690733597.txt.gz · Last modified: 2023/07/30 16:13 by colin