Differences

This shows you the differences between two versions of the page.

--- laser_cutter_training_sop [2023/05/31 21:05] – haley
+++ laser_cutter_training_sop [2024/09/30 20:03] (current) – kho
@@ Line 1: / Line 1: @@
-=====CNSI Innovation Workshop and Microfluidics Lab Trotec Speedy100 Safe Operating Procedures=====
+=====CNSI Trotec Speedy100 Safe Operating Procedures=====
-Last Updated: 5/31/23 Haley \\
+Last Updated: 7/17/23 Rachel \\
 This SOP is compiled from the following sources. For more information reference these sources.
   * [[https://www.troteclaser.com/fileadmin/content/images/Contact_Support/Manuals/8010-Speedy-100-Manual-EN.pdf|Trotec Speedy Manual]]
@@ Line 18: / Line 18: @@
 ====Location====
-The Trotec Laser printer is located upstairs in the Microfluidics Lab next to the Haas CNC machine in the back of the room.
+The Trotec Laser printer is located upstairs in Elings 3430 next to the Haas CNC machine in the back of the room.
 ====Overview====
@@ Line 61: / Line 61: @@
   * ABS (acrylonitrile butadiene styrene)
   * Acrylic (also known as Plexiglas, Lucite, PMMA)
-  * Delrin (POM, acetal) — for a supplier, try www.mcmaster.com.
+  * Delrin (POM, acetal) — **Must use nitrogen assist when cutting delrin**
   * Kapton tape (Polyimide)
   * Mylar (polyester)
@@ Line 165: / Line 165: @@
 |}
-====General Curf Width For Acrylic====
+====General Kerf Width For Acrylic====
 {| style=""
 |+
@@ Line 171: / Line 171: @@
 Thickness
 !
-Curf Width
+Kerf Width
 |-
 |