Differences

This shows you the differences between two versions of the page.

--- h2d_sop [2025/09/26 19:06] – colin
+++ h2d_sop [2025/10/01 16:47] (current) – colin
@@ Line 31: / Line 31: @@
       - Select "IW_H2D-1" for the printer
       - Make sure only "Bed Leveling" and "Enable AMS" is selected and start print
+====Dual Material Printing====
+  - Within Bambu Slicer, follow these tutorials to slice in dual materials:
+    * [[https://wiki.bambulab.com/en/software/bambu-studio/multi-color-printing|Bambu Labs Tutorial]]
+    * [[https://www.youtube.com/watch?v=xwuf-kZlpH8&t=163s|Youtube Tutorial]]
+  - To swap filament navigate to Filament Icon->Left Spool->Unload within the H2D display,
+  - Allow H2D to unload filament, follow instructions accordingly
+  - Once unloaded, remove the spool from the Creality filament dryer
+  - Respool the filament neatly and store in proper bin
+  - Place desired filament spool into the Creality Filament dryer
+  - Insert the filament through the bowden tube until it can't be inserted further
+  - Within the H2D display, navigate to Filament Icon -> Left Spool -> Load, follow instructions accordingly
 ====Post Processing====
@@ Line 43: / Line 57: @@
 ====Bambu Studio Software Information====
-{{:bambuprintersettings.jpg?600}}
+{{:h2d_printer_preset.png?300|}}\\
+{{:h2d_nozzle_diameter.png?200|}}
+{{:h2d_buildplate_preset.png?200|}}
   - Select the correct nozzle that you are using. (Typically, the 0.4 nozzle is the one in the printer)