formwash_cleaner
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| formwash_cleaner [2026/02/04 18:47] – colin | formwash_cleaner [2026/02/04 18:47] (current) – [Operating Procedures] colin | ||
|---|---|---|---|
| Line 28: | Line 28: | ||
| - Remove build platform from Formlabs 3D printer, making sure to keep a tray under the platform to prevent drips | - Remove build platform from Formlabs 3D printer, making sure to keep a tray under the platform to prevent drips | ||
| - Wake the Form Wash using the large dial located bottom right of the front face, select " | - Wake the Form Wash using the large dial located bottom right of the front face, select " | ||
| - | - Load the build platform onto the mount arms. Adjust the position of the mount arms according to the size of the platform. (see below reference picture) \\ {{: | + | - Load the build platform onto the mount arms. Adjust the position of the mount arms according to the size of the platform. (see reference picture |
| - If prints were removed prints from build platform, load them into Form Wash basket. | - If prints were removed prints from build platform, load them into Form Wash basket. | ||
| - Using the dial select the desired amount of time, click " | - Using the dial select the desired amount of time, click " | ||
formwash_cleaner.txt · Last modified: 2026/02/04 18:47 by colin