Differences

This shows you the differences between two versions of the page.

--- ultimaker_3_quick_review [2020/08/18 17:59] – furst
+++ ultimaker_3_quick_review [2020/08/18 18:35] – [Maintenance] furst
@@ Line 1: / Line 1: @@
 =====Ultimaker 3 Extended=====
-last updated: 8/18 By: Furst
+Tool Lead: Andrew Furst \\
+Contact: Andrewfurst@ucsb.edu
-=====Safety Concerns=====
+====Safety Concerns====
   * Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time.
   * Keep hands clear of printer during operation. Pause print before clearing or adjusting print.
+ ====Safe Operating Procedures Review====
-=====Safe Operating Procedures Review=====
   - Launch Cura version 4 (blue icon)
   - From connected printers, select IW-Ultimaker3
@@ Line 19: / Line 18: @@
 Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired.
-=====Post Processing=====
+====Post Processing====
-  * If support was used carefully remove support structure if
+  * If support was constructed from ABS carefully break away with pliers
+  * If support was constructed from PVA soak part in warm water for several hours to dissolve support structure
+====Maintenance====
+  * Bed should be cleaned with IPA between prints
+  * Print heads and silicone head protector should be cleaned as needed
+  * Filament should be dried before use if printer has been idle for several weeks
+  * Bed leveling should be completed every time print cores are swapped
+  * Print cores should be swapped after clog or to change print line width. Used print heads should be kept for spare parts
 -----
+do=export_http://microfluidics.cnsi.ucsb.edu/wiki/doku.php?id=ultimaker_3_quick_review