ultimaker_3_quick_review
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
ultimaker_3_quick_review [2020/08/18 18:17] – [Maintenance] furst | ultimaker_3_quick_review [2020/08/18 18:48] (current) – [Maintenance] furst | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | =====Ultimaker 3 Extended===== | + | =====Ultimaker 3 Extended===== |
- | last updated: 8/18 By: Furst | + | Tool Lead: Andrew |
- | + | Contact: Andrewfurst@ucsb.edu | |
- | =====Safety Concerns===== | + | ====Safety Concerns==== |
* Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time. | * Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time. | ||
* Keep hands clear of printer during operation. Pause print before clearing or adjusting print. | * Keep hands clear of printer during operation. Pause print before clearing or adjusting print. | ||
- | + | | |
- | =====Safe Operating Procedures Review===== | + | |
- Launch Cura version 4 (blue icon) | - Launch Cura version 4 (blue icon) | ||
- From connected printers, select IW-Ultimaker3 | - From connected printers, select IW-Ultimaker3 | ||
Line 19: | Line 18: | ||
Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired. | Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired. | ||
- | =====Post Processing===== | + | ====Post Processing==== |
* If support was constructed from ABS carefully break away with pliers | * If support was constructed from ABS carefully break away with pliers | ||
* If support was constructed from PVA soak part in warm water for several hours to dissolve support structure | * If support was constructed from PVA soak part in warm water for several hours to dissolve support structure | ||
- | =====Maintenance===== | + | ====Maintenance==== |
* Bed should be cleaned with IPA between prints | * Bed should be cleaned with IPA between prints | ||
* Print heads and silicone head protector should be cleaned as needed | * Print heads and silicone head protector should be cleaned as needed | ||
Line 31: | Line 30: | ||
----- | ----- | ||
+ | |||
+ |
ultimaker_3_quick_review.1597774632.txt.gz · Last modified: 2020/08/18 18:17 by furst