ultimaker_3_quick_review
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
ultimaker_3_quick_review [2020/08/18 17:36] – created furst | ultimaker_3_quick_review [2020/08/18 18:48] (current) – [Maintenance] furst | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Operating Procedures | + | =====Ultimaker 3 Extended===== |
+ | Tool Lead: Andrew Furst \\ | ||
+ | Contact: Andrewfurst@ucsb.edu | ||
+ | ====Safety Concerns==== | ||
+ | * Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time. | ||
+ | * Keep hands clear of printer during operation. Pause print before clearing or adjusting print. | ||
+ | | ||
- Launch Cura version 4 (blue icon) | - Launch Cura version 4 (blue icon) | ||
- From connected printers, select IW-Ultimaker3 | - From connected printers, select IW-Ultimaker3 | ||
Line 12: | Line 17: | ||
- Connect thumb drive to printer -> select desired file -> select print\\ | - Connect thumb drive to printer -> select desired file -> select print\\ | ||
Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired. | Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired. | ||
+ | |||
+ | ====Post Processing==== | ||
+ | * If support was constructed from ABS carefully break away with pliers | ||
+ | * If support was constructed from PVA soak part in warm water for several hours to dissolve support structure | ||
+ | |||
+ | ====Maintenance==== | ||
+ | * Bed should be cleaned with IPA between prints | ||
+ | * Print heads and silicone head protector should be cleaned as needed | ||
+ | * Filament should be dried before use if printer has been idle for several weeks | ||
+ | * Bed leveling should be completed every time print cores are swapped | ||
+ | * Print cores should be swapped after clog or to change print line width. Used print heads should be kept for spare parts | ||
----- | ----- | ||
+ | |||
+ |
ultimaker_3_quick_review.1597772202.txt.gz · Last modified: 2020/08/18 17:36 by furst