Differences

This shows you the differences between two versions of the page.

--- thermoline_furnace [2023/01/05 22:26] – [Thermoline 1315M Furnace] haley
+++ thermoline_furnace [2023/01/30 22:34] (current) – bdincau
@@ Line 4: / Line 4: @@
 ^                   Thermoline Furnace                            ^
 |   {{ :tools:thermolinefurnace:thermoline_furnace.jpg?nolink&200 |}}   |
-| **Tool Type:**                  Furnace                          |
+| **Tool Type:**                  Box Furnace                          |
 | **Location:**                   Microfluidics Lab                           |
-| **Description:**                Furnace                          |
+| **Description:**                Small High-Temperature (1000 C) Box Furnace                          |
 | **Manufacturer:**               Thermoline                          |
-----
 ===== About =====
-"The furnace chamber is heated by a single three section resistant heater which is embedded in a refractory material. The chamber is
+From the manufacturer: The furnace chamber is heated by a single three section resistant heater which is embedded in a refractory material. The chamber is
 insulated with a ceramic fiber insulation. The
 temperature is controlled by an electronic control. The temperature is measured by a thermocouple and is registered on a digital display. For
@@ Line 21: / Line 22: @@
 remove power from the heating elements when
 the door is opened. The furnace is supported by
-the control section which also houses the electrical connections."
+the control section which also houses the electrical connections.
 ----
 ===== Safety Concerns =====
+  * High Temperature
+  * No combustibles or hazardous materials
+  * Thermally insulating gloves must be worn when working with hot items.
+  * Do not use to heat food.
+  * Never heat a sealed container.
+  * Do not operate the furnace if it is damaged, or is not working properly. Please place a note on the oven to alert other users, and notify laboratory staff of the problem.
+  * **Double containment is required for heating containers of liquid to prevent leaked material from contaminating the oven. This is especially true when heating PDMS molds.**
 ----
@@ Line 32: / Line 39: @@
-----
+) Plug in the furnace and power on. \\
+) Set the desired temperature using the up/down arrow buttons on the controller. \\
+) Locate at pair of thermally insulated gloves, usually near the convention ovens. \\
+) Once the desired temperature is reached, place your item(s) in the furnace while wearing insulated gloves. Remember, all liquids must be double contained so that if they spill, the oven remains clean. \\
+) If performing multiple steps, adjust the temperature when needed. \\
+) When finished, power off and unplug the furnace. Close the door and leave a note if the furnace is still hot when you leave.
+-----
 ===== Detailed Specifications =====