sherline_training_sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
sherline_training_sop [2022/10/03 20:40] – furst | sherline_training_sop [2022/10/05 22:16] – furst | ||
---|---|---|---|
Line 63: | Line 63: | ||
* Cleaning | * Cleaning | ||
* Remember to enter job information into the 3D print job log! | * Remember to enter job information into the 3D print job log! | ||
+ | {{: | ||
====Safety==== | ====Safety==== | ||
Line 89: | Line 90: | ||
====CNC Setup==== | ====CNC Setup==== | ||
- | | + | {{: |
+ | | ||
- On the Sherline computer, start FlashCut CNC (thunderbolt icon) | - On the Sherline computer, start FlashCut CNC (thunderbolt icon) | ||
- Within FlashCut, select the home tab, followed by seek home. This will move all axis to their zero position. | - Within FlashCut, select the home tab, followed by seek home. This will move all axis to their zero position. | ||
Line 106: | Line 108: | ||
- clamp the bonded sample into the top left corner of the fixture | - clamp the bonded sample into the top left corner of the fixture | ||
- | - Without changing the coordinates, | + | - Without changing the coordinates, |
- Using the jog commands, position the spindle over a sacrificial portion of the sample | - Using the jog commands, position the spindle over a sacrificial portion of the sample | ||
- slowly ramp the spindle speed up to full speed and apply diluted Kool Mist coolant over the sample and within the fixture. | - slowly ramp the spindle speed up to full speed and apply diluted Kool Mist coolant over the sample and within the fixture. | ||
- | - using incremental jog, slowly | + | - using incremental jog on slow speed, slowly |
- | - zero the program Z axi. | + | - zero the program Z axis. |
- raise the spindle using the jog function and turn off the spindle. | - raise the spindle using the jog function and turn off the spindle. | ||
Line 165: | Line 167: | ||
* No additional charges result from tool time | * No additional charges result from tool time | ||
* Used drill bits are free | * Used drill bits are free | ||
- | * If a new dill bit is selected, ensure it is logged within FBS so recharge can be applied | + | * If a new dill bit is selected, ensure it is logged within FBS so recharge can be applied |
----- | ----- | ||
sherline_training_sop.txt · Last modified: 2022/10/05 22:18 by furst