sherline_cnc_mill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
sherline_cnc_mill [2022/09/12 22:29] – [About] haley | sherline_cnc_mill [2023/07/18 20:03] (current) – rylin | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Flashcut / Sherline CNC Mill ====== | + | ====== Flashcut / Sherline CNC Drill ====== |
- | Haley Holcomb 8/26/22 | + | |
- | ^ Flashcut / Sherline | + | ^ |
| {{ : | | {{ : | ||
- | | **Tool Type: | + | | **Tool Type: |
- | | **Location: | + | | **Location: |
- | | **Supervisor** | + | | **Description: |
- | | David Bothman | + | | **Manufacturer: |
- | | (805) 893-4125 | + | |
- | | bothman@cnsi.ucsb.edu | + | |
- | + | ||
- | | **Description: | + | |
- | | **Manufacturer: | + | |
+ | Last updated 9/12/22 Haley | ||
---- | ---- | ||
===== About ===== | ===== About ===== | ||
- | CNC diamond drill typically | + | The CNC diamond drill is used to drill holes in glass slides. Uses FlashCut CNC software to interpret G-code and drill holes in programmed locations. |
---- | ---- | ||
- | ===== Detailed Specifications | + | ===== Safety Concerns |
- | + | Eye injuries can result from flying chips or broken bits. Cuts can occur from contacting sharp tools or broken glass. Burns can result from hot cutting tools or parts. Serious injury can result from pinching or entanglement in moving parts. Poor housekeeping creates tripping and cutting hazards for other users. Do not leave machine running unattended. Eye protection, closed toe shoes, long pants, and protective clothing must be worn when using this machine to prevent injury. Long hair must be tied back and jewelry must be removed before operating this machine to prevent entanglement. | |
- | Insert Text Here! | + | |
---- | ---- | ||
- | ===== Safety Concerns | + | ===== Training Documentation |
- | Insert Text Here! | + | [[Sherline Training SOP|]] |
---- | ---- | ||
- | ===== Operating Procedures | + | ===== Detailed Specifications |
- | + | * Stepper motor mounts and couplers on X-, Y- and Z-axes | |
- | Insert Text Here! | + | * 70-2800 RPM continuously variable by electronic speed control |
+ | * Maximum CNC travel positioning speed: 22 in/min | ||
+ | * Max clearance (table to spindle): 8.00″ (203 mm) | ||
+ | * Travel axes x,y,z: 8.65″ (220 mm), 5.00″ (127 mm), 6.25″ (159 mm) | ||
+ | * CNC Stepper motor holding torque: 136 oz-in | ||
---- | ---- | ||
+ | |||
+ | |||
+ | |||
===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
Line 54: | Line 56: | ||
{{: | {{: | ||
----- | ----- | ||
- | ===== Training Documentation ===== | ||
- | |||
- | Insert Text Here! | ||
- | ---- | ||
sherline_cnc_mill.1663021742.txt.gz · Last modified: 2022/09/12 22:29 by haley