Differences

This shows you the differences between two versions of the page.

--- sca_naoh_bath [2023/01/06 00:53] – haley
+++ sca_naoh_bath [2023/01/06 01:31] (current) – [SCA 1200 HT NaOH Parts Bath] haley
@@ Line 11: / Line 11: @@
 | **Manufacturer:**               PADT                          |
+Last updated 1/5/23 Haley
 ----
@@ Line 21: / Line 22: @@
 ===== Safety Concerns =====
-This tool makes use of a heated solvent! A lab coat, face shield, and nitrile gloves must be wore by the user whenever the SCA 1200 HT is to be opened to protect for solution and vapor fumes. In case of contact with solution flush eyes, and skin with water, remove all contaminated clothing, and get medical attention immediately.
+This tool makes use of a heated solvent! A lab coat, face shield, and nitrile gloves must be wore by the user whenever the SCA 1200 HT is to be opened to protect from solution and vapor fumes. In case of contact with solution flush eyes, and skin with water, remove all contaminated clothing, and get medical attention immediately.
 ----
@@ Line 29: / Line 30: @@
   - Remove completed part on build tray from F270 3D printer
   - Remove part from build tray, making sure to scrape build tray free of ALL residue
-  - Dawn lab coat, nitrile gloves, and a face shield
+  - Put on a lab coat, nitrile gloves, and a face shield
   - Open lid on SCA 1200 HT
   - Slowly lift large basket, allow time to for excess solution to drip back into SCA 1200HT \\ NOTE: If solution rises above specific level alarm will sound, this is common when lifting or lowering basket and means you're moving too fast!
@@ Line 39: / Line 40: @@
   - Follow steps 3-6 to remove part, followed by steps 8 to replace basket
   - Part should be allowed to drip, before being rinsed in sink with plenty of warm water
 ----