sandersop
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| sandersop [2022/07/14 19:47] – [Training] dave | sandersop [2022/07/14 20:06] – dave | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | =====CNSI Innovation Workshop Combination Sander User Outline===== | + | =====CNSI Innovation Workshop |
| - | This guide may be found online through the Innovation Workshop and Microfluidics wiki. | + | |
| ====Location==== | ====Location==== | ||
| The combination belt/disk sander is located in 2448 Elings Hall on the bench next to Fume Hood #3. | The combination belt/disk sander is located in 2448 Elings Hall on the bench next to Fume Hood #3. | ||
| Line 40: | Line 39: | ||
| * In the event of injury, contact lab staff and emergency services if necessary (?) | * In the event of injury, contact lab staff and emergency services if necessary (?) | ||
| ====Maintenance==== | ====Maintenance==== | ||
| - | * Use wire brushes to clear metal residue out of grinding wheel | + | * Change sandpaper as necessary |
| - | * Adjust grinding wheel guide as wheel wears | + | * Clean dust off of machine and work area |
| ====Supplies (In drawer labeled “Grinder Accessories”)==== | ====Supplies (In drawer labeled “Grinder Accessories”)==== | ||
| * 1" x 42" sanding belts | * 1" x 42" sanding belts | ||
sandersop.txt · Last modified: 2022/07/14 20:20 by dave