lab-oven-sop
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
lab-oven-sop [2022/05/20 17:57] – created petreikis | lab-oven-sop [2023/01/05 22:06] (current) – [Max Temperatures] haley | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====CNSI Innovation Workshop and Microfluidics Lab Laboratory Ovens Operating Procedures===== | =====CNSI Innovation Workshop and Microfluidics Lab Laboratory Ovens Operating Procedures===== | ||
- | Last Updated: Bothman(5/9/22) \\ | + | Last updated 1/5/23 Haley \\ |
- | This SOP is compiled from the following sources. For more information reference these sources. | + | |
- | * [[https:// | + | |
- | * {{ : | + | |
- | * {{ : | + | |
- | + | ||
- | ====Training Checklist==== | + | |
| | ||
====Location==== | ====Location==== | ||
+ | *Thermoline / Lindberg Blue M Oven (Room 2448) | ||
+ | *Yamoto DKN400 | ||
+ | *Lindberg Blue M Convection Oven (Room 3430) | ||
====Overview==== | ====Overview==== | ||
Line 42: | Line 39: | ||
-The ovens in room 3430 are usually left powered on. The oven in 2448 is usually turned off after each run, but may be left on if repeated runs are planned. | -The ovens in room 3430 are usually left powered on. The oven in 2448 is usually turned off after each run, but may be left on if repeated runs are planned. | ||
+ | ====Max Temperatures==== | ||
+ | *Yamoto DKN400: 260C | ||
+ | *Lindberg Blue M Convection Oven: 300C | ||
+ | *Thermoline / Lindberg Blue M Oven: | ||
+ | |||
+ | |||
+ | ====Changing the oven set point==== | ||
+ | **Blue M Ovens:** | ||
+ | *Use the ↑↓ to adjust the temperature | ||
+ | *Press the **SET/ENT** button | ||
+ | |||
+ | **Yamoto Oven: Operating range** | ||
+ | *Press **FIXED TEMP** | ||
+ | *Use the ↑↓ to adjust the temperature | ||
+ | *Press the **SET/ENT** button | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ====Setting the countdown timers==== | ||
+ | **Ovens in room 3430** | ||
+ | *Press **1** | ||
+ | *Enter the run time (**HMS buttons**) | ||
+ | *Press **1** to start the countdown | ||
+ | *Press and hold **1** to reset | ||
+ | |||
+ | **Oven in 2448** | ||
+ | *Make sure that the slide switch on the right is on countdown | ||
+ | *Enter the run time (HMS Buttons) | ||
+ | *Press Start/Stop | ||
+ | |||
+ | References: | ||
+ | * {{https:// | ||
+ | * {{ : | ||
lab-oven-sop.1653069474.txt.gz · Last modified: 2022/05/20 17:57 by petreikis