formcure_uv
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
formcure_uv [2020/10/08 16:59] – [Detailed Specifications] furst | formcure_uv [2023/01/06 00:41] – haley | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== FormCure UV Curing Station ====== | ====== FormCure UV Curing Station ====== | ||
- | ^ | + | ^ |
| {{ : | | {{ : | ||
- | | **Tool Type: | + | | **Tool Type: |
- | | **Location: | + | | **Location: |
- | | **Supervisor** | ||
- | | David Bothman | ||
- | | (805) 893-4125 | ||
- | | bothman@cnsi.ucsb.edu | ||
- | | **Description: | ||
- | | **Manufacturer: | ||
+ | | **Description: | ||
+ | | **Manufacturer: | ||
+ | |||
+ | Last updated 1/5/23 Haley | ||
---- | ---- | ||
===== About ===== | ===== About ===== | ||
- | Some FormLabs | + | After your FormLabs |
- | + | ||
- | ---- | + | |
- | + | ||
- | ===== Detailed Specifications ===== | + | |
- | * Max cure temp: 80 degrees C | + | |
- | * Light: 39W total drawn by 13 405 nm LEDs | + | |
---- | ---- | ||
Line 45: | Line 36: | ||
- Use the dial on the front of the FormCure to set time and temperature | - Use the dial on the front of the FormCure to set time and temperature | ||
- Place part within the FormCure-> | - Place part within the FormCure-> | ||
+ | |||
+ | ----- | ||
+ | |||
+ | ===== Detailed Specifications ===== | ||
+ | * Max cure temp: 80 degrees C | ||
+ | * Light: 39W total drawn by 13 405 nm LEDs | ||
+ | |||
+ | |||
---- | ---- | ||
+ | |||
===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
+ | |||
+ | [[form2sop|Form 2 Training SOP]] | ||
+ | |||
[[https:// | [[https:// | ||
Line 58: | Line 61: | ||
- | ===== Training Documentation ===== | ||
- | Insert Text Here! | ||
- | ---- |
formcure_uv.txt · Last modified: 2023/01/06 00:43 by haley