form2sop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
form2sop [2022/08/25 17:39] – removed quick review wei | form2sop [2022/09/19 16:43] (current) – haley | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====Form 2/3 Training SOP===== | =====Form 2/3 Training SOP===== | ||
- | Last edited: | + | Last edited: |
====Training Checklist: | ====Training Checklist: | ||
Line 71: | Line 71: | ||
====Using the Form Wash:==== | ====Using the Form Wash:==== | ||
- | * Transport the part and build platform in the container | + | * Transport the part and build platform in the container |
* Wear a lab coat and safety goggles, as the Form Wash contains IPA. | * Wear a lab coat and safety goggles, as the Form Wash contains IPA. | ||
* Press ‘Open’ | * Press ‘Open’ | ||
Line 83: | Line 83: | ||
**Using the Form Cure:**\\ | **Using the Form Cure:**\\ | ||
* Release the part from the build platform: | * Release the part from the build platform: | ||
- | * Place build platform on the removal jig. Tools are in the Fume Hood #4 in Elings 2442. | + | * Place build platform on the removal jig. |
* Slide a removal tool under the angled edge of the part’s base to separate it from the build platform. | * Slide a removal tool under the angled edge of the part’s base to separate it from the build platform. | ||
* Lift the cover of the Form Cure. Place the part in the center of the turntable. | * Lift the cover of the Form Cure. Place the part in the center of the turntable. |
form2sop.1661449144.txt.gz · Last modified: 2022/08/25 17:39 by wei