Differences

This shows you the differences between two versions of the page.

--- f270_sop [2020/08/27 16:45] – [Maintenance Schedule (see user maintenance page 80):] furst
+++ f270_sop [2022/07/01 17:13] (current) – [Part Removal and Cleaning] haley
@@ Line 94: / Line 94: @@
   * If support was used, submerge print in warm water for several hours to dissolve PVA filament. (prints can warp if submerged in water for over 24 hours) \\
 **F270**
-  * Don gloves, face shield, and lab coat
+  * Remove the build tray and flex it to break the bond between the material and the tray.
-  * Carefully, slowly and without splashing cleaning solution open the support removal tank lid, remove and open the tank
+  * Separate your part from the build tray with a spatula and scrape off any debris so they tray can be reused.
+  * Put on the appropriate PPE: don gloves, a face shield, and a lab coat.
+  * Carefully, slowly, and without splashing cleaning solution, open the support removal tank lid and remove and open the tank.
   * Place large parts directly in the tank, small parts may be put in the SS box and placed into the main basket.
-  * Carefully, slowly and without splashing lower the basket back into the tank and close the lid.
+  * Carefully, slowly, and without splashing lower the basket back into the tank and close the lid.
-  * Set timer for 6 hours setting the temperature to 80 degrees C.
+  * Set timer for 8 hours using the "set" button.
-  * After cleaning time has elapsed follow the instructions above for opening and removing parts.
+  * Select the temperature to be 70 degrees C and push the power button to warm the tank.
-  * Rinse part in warm water
+  * After cleaning time has elapsed, follow the instructions above for opening and removing parts.
+  * Rinse part in warm water.
 ----