Microfluidics Lab and Innovation Workshop Wiki

User Tools

Site Tools

Trace:
crystalmarksop

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
crystalmarksop [2023/12/01 01:02] – [Safe Operating Procedures Review] colincrystalmarksop [2023/12/01 01:04] – [Safe Operating Procedures Review] colin
Line 52: Line 52:
   - "Set" -> "Zero X", "Set" -> "Zero Y"    - "Set" -> "Zero X", "Set" -> "Zero Y" 
   - Note that origin is displayed in "DXF to G-Code Converter" (You can modify the origin in the software your .dxf was created): \\ {{:dxfzero.jpg?direct&200|}}   - Note that origin is displayed in "DXF to G-Code Converter" (You can modify the origin in the software your .dxf was created): \\ {{:dxfzero.jpg?direct&200|}}
 +  - Use tape and/or turn on vaccum to fixture part (optional)
   - Begin etching : "G-Code" -> "Start"   - Begin etching : "G-Code" -> "Start"
   - Monitor operation   - Monitor operation
crystalmarksop.txt · Last modified: 2024/01/22 17:54 by bdincau