Differences

This shows you the differences between two versions of the page.

--- bandsaw_sop [2022/07/13 21:43] – dave
+++ bandsaw_sop [2022/07/15 15:21] (current) – dave
@@ Line 78: / Line 78: @@
 The bandsaw motor connects to the blade drive via a two speed belt drive. The belt must be in the low range for cutting stainless steel and titanium. All other materials may be cut with the belt in high range. The controller has 4 material categories pre-programmed: wood, metal, non-ferrous metals and plastic. Within each category 4 materials are programmed. These preset speeds are listed below. The speeds are listed in two units (sfm/rpm): surface feet per minute (sfm)/ and revolutions per minute (rpm). The conversion factor between sfm and rpm changes with the position of the belt on the drive pulley.
-Wood:
-  * Resaw: 4000/2160
-  * Bowl blank: 3000/1620
-  * **Rip/Crosscut: 2500/1350**
-  * Scroll pattern: 2000/1000
-Metal:
-  * Carbon steel: 250/135
-  * Stainless steel: 100/100
-  * Titanium: 75/75
-  * Cast iron: 160/100
-Non-ferrous metals:
-  * Aluminum: 400/215
-  * Brass: 250/135
-  * Bronze: 220/115
-  * Copper: 200/105
-Plastic:
-  * Acrylic: 2500/1350
-  * Nylon: 1500/810
-  * HDPE: 2000/1080
-  * Custom: 2000/1080
 The speed adjust dial on the controller is used to adjust the speed up and down from these preset levels. If the saw is making a lot of noise, try lowering the speed.
@@ Line 106: / Line 83: @@
 **Manuals:**
   * {{ :tools:rikonbandsaw:https_www.rikontools.com_manuals_10-326.pdf |}}
+  * {{ :tools:rikonbandsaw:striatech_information.pdf |}}
 **Other SOP’s:**
-**MSDS:**
 **Sources for Supplies:**
@@ Line 164: / Line 140: @@
 Other References:
-  * {{ :tools:rikonbandsaw:striatech_information.pdf |}}