Differences

This shows you the differences between two versions of the page.

--- bandsaw_sop [2020/08/14 17:48] – [References] furst
+++ bandsaw_sop [2022/07/15 15:21] (current) – dave
@@ Line 73: / Line 73: @@
   * Resaw bar assembly is kept in the cabinet of the bandsaw stand. Use this to prevent the bandsaw blade from walking and moving during the cut.
+====Recommended blade selection and speed====
+In general, we want at least three cutting teeth to be in contact with the material being cut. So thinner materials require a finer tooth blade than thick materials. Please see lab staff for instruction on changing blades.
+The bandsaw motor connects to the blade drive via a two speed belt drive. The belt must be in the low range for cutting stainless steel and titanium. All other materials may be cut with the belt in high range. The controller has 4 material categories pre-programmed: wood, metal, non-ferrous metals and plastic. Within each category 4 materials are programmed. These preset speeds are listed below. The speeds are listed in two units (sfm/rpm): surface feet per minute (sfm)/ and revolutions per minute (rpm). The conversion factor between sfm and rpm changes with the position of the belt on the drive pulley.
+The speed adjust dial on the controller is used to adjust the speed up and down from these preset levels. If the saw is making a lot of noise, try lowering the speed.
 ====References====
 **Manuals:**
   * {{ :tools:rikonbandsaw:https_www.rikontools.com_manuals_10-326.pdf |}}
+  * {{ :tools:rikonbandsaw:striatech_information.pdf |}}
 **Other SOP’s:**
-**MSDS:**
 **Sources for Supplies:**
@@ Line 85: / Line 91: @@
 **Contact Information:**
-**Recipes:**
+**Recipes:** \\
+General rule of thumb for TPI: always at a minimum have 3 teeth worth of engagement in your material at a time.\\
 {| style=""
 |+ Bandsaw Feeds and Speeds
@@ Line 129: / Line 136: @@
 |
 FPM
 |}
 Other References:
-  * {{ :tools:rikonbandsaw:striatech_information.pdf |}}