3d_print_water_jet_cleaning_station
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| 3d_print_water_jet_cleaning_station [2023/01/06 00:35] – [Operating Procedures] haley | 3d_print_water_jet_cleaning_station [2023/01/06 01:20] – [Operating Procedures] haley | ||
|---|---|---|---|
| Line 33: | Line 33: | ||
| - Place part within the pressure washer and open the DI valve on the sink. The power switch is located on the back of the washing enclosure. | - Place part within the pressure washer and open the DI valve on the sink. The power switch is located on the back of the washing enclosure. | ||
| - Using the foot pedal, clean the part using the high pressure nozzles located within the enclosure | - Using the foot pedal, clean the part using the high pressure nozzles located within the enclosure | ||
| - | - After part has been cleaned, **ensure the water is switched off** as leaks have occurred within Elings Hall before and will damage equipment | + | - After part has been cleaned, **ensure |
| - To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours | - To achieve optimal mechanical properties, or if part is to be used as a mold for casting, part should be baked at 60 degrees C for a minimum of 4 hours | ||
3d_print_water_jet_cleaning_station.txt · Last modified: 2023/07/12 17:05 by rylin