Differences

This shows you the differences between two versions of the page.

--- x1carbon_sop [2024/08/30 17:18] – kho
+++ x1carbon_sop [2024/08/30 17:54] (current) – kho
@@ Line 56: / Line 56: @@
-**Cura Print Settings**
-  -   //Printer Type//: Choose Ultimaker 3 or Ultimaker 5 Extended.
-  -   //Material Type//: This allows you to choose the material type you have loaded into the printer. Ensure that both the material type as well as the printhead diameter settings match the printheads on the printer
-  -   //Layer thickness, infill, support//: Allows you to adjust the thickness, infill, and support you wish to use. **Ensure that you enable adhesion**