Differences

This shows you the differences between two versions of the page.

--- x1carbon_sop [2024/08/19 21:31] – [Training Checklist:] kho
+++ x1carbon_sop [2024/08/30 17:54] (current) – kho
@@ Line 42: / Line 42: @@
 ====Bambu Studio Software Information====
-{{:bambustudioguide1.jpg?600}}
+{{:bambuprintersettings.jpg?600}}
-  -    //Auto Orient//: Gives you the recommended orientation for your print. Usually is the best orientation, but you should still think about specific qualities of your print and limitations of the printer.
+  - Select the correct nozzle that you are using. (Typically, the 0.4 nozzle is the one in the printer)
+  - Make sure the "Textured PEI Plate" is selected
+{{:bambuprintersettings2.jpg?600}}
+  -    //Auto Orient//: Gives you the recommended orientation for your print. Usually is the best orientation, but you should still think about specific dimensions and features of your print and the limitations of the printer.
   -    //Arrange//: Arranges your models near the center of the build tray
   -    //Move//: Allows you to move your model with a relative coordinate system
@@ Line 51: / Line 56: @@
-**Cura Print Settings**
-  -   //Printer Type//: Choose Ultimaker 3 or Ultimaker 5 Extended.
-  -   //Material Type//: This allows you to choose the material type you have loaded into the printer. Ensure that both the material type as well as the printhead diameter settings match the printheads on the printer
-  -   //Layer thickness, infill, support//: Allows you to adjust the thickness, infill, and support you wish to use. **Ensure that you enable adhesion**