wen_drill_press
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| wen_drill_press [2023/01/05 02:45] – haley | wen_drill_press [2024/09/26 19:43] (current) – epace | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== WEN vertical Drill Press ====== | ====== WEN vertical Drill Press ====== | ||
| - | ^ WEN vertical | + | ^ Drill Press ^ |
| | {{: | | {{: | ||
| - | | **Tool Type: | + | | **Tool Type: |
| - | | **Location: | + | | **Location: |
| - | | **Supervisor** | + | | **Description: |
| - | | David Bothman | + | | **Manufacturer: |
| - | | (805) 893-4125 | + | |
| - | | bothman@cnsi.ucsb.edu | + | |
| - | + | ||
| - | | **Description: | + | |
| - | | **Manufacturer: | + | |
| ---- | ---- | ||
| Line 24: | Line 19: | ||
| ===== Safety Concerns ===== | ===== Safety Concerns ===== | ||
| - | * Safety glasses, | + | * Safety glasses, |
| * Metal chips can be incredibly sharp, do not touch any chips directly instead using an acid brush to remove chips | * Metal chips can be incredibly sharp, do not touch any chips directly instead using an acid brush to remove chips | ||
| * Do not inhale any fumes resulting from drilling using oil | * Do not inhale any fumes resulting from drilling using oil | ||
| Line 47: | Line 42: | ||
| ---- | ---- | ||
| - | ===== Operating Procedures ===== | ||
| - | - Layout and center punch the holes you wish to drill | ||
| - | - Collect all necessary tools for your drilling operation. | ||
| - | - Insert the bit into the drill chuck, tighten with the chuck key, and remove the chuck key before continuing. | ||
| - | - Align the holes with the drill bit and secure the part using the vice or the drill bed clamp. | ||
| - | - Adjust the work table to the appropriate height and lock securely. | ||
| - | - Check that the tool can spin freely and that it is clear of the part. | ||
| - | - Adjust feed rate | ||
| - | - Apply cutting lubricant to the part. | ||
| - | - Turn the machine on (Do not leave running unattended). | ||
| - | - Use peck drilling operations to drill the hole, remove material in 0.05 inch increments. | ||
| - | - Remove chips and swarf using a brush. | ||
| - | - Power down the machine when done. | ||
| - | - Use a brush and/or rag to clean up any chips, shavings, and oil from the drill press and the surrounding areas. | ||
| - | - Return all tools to their proper location and power down the drill press.Tidy up the work area. | ||
| - | |||
| - | ---- | ||
| ===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
wen_drill_press.1672886712.txt.gz · Last modified: 2023/01/05 02:45 by haley