wen_drill_press
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
wen_drill_press [2020/07/13 19:06] – created furst | wen_drill_press [2024/09/26 19:43] (current) – epace | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== WEN vertical Drill Press ====== | ====== WEN vertical Drill Press ====== | ||
- | ^ WEN vertical | + | ^ Drill Press ^ |
| {{: | | {{: | ||
- | | **Tool Type: | + | | **Tool Type: |
- | | **Location: | + | | **Location: |
- | | **Supervisor** | + | | **Description: |
- | | David Bothman | + | | **Manufacturer: |
- | | (805) 893-4125 | + | |
- | | bothman@cnsi.ucsb.edu | + | |
- | + | ||
- | | **Description: | + | |
- | | **Manufacturer: | + | |
---- | ---- | ||
===== About ===== | ===== About ===== | ||
+ | This vertical drill press is one of the largest upright tools in the Innovations Workshop. It has a speed control lever on the left side of the head, and a vertical quill feed on the right. The chuck key is located on the right side of the head and should be replaced after use to avoid mixing chuck keys. | ||
---- | ---- | ||
- | ===== Detailed Specifications | + | ===== Safety Concerns |
+ | |||
+ | * Safety glasses, closed toe shoes, and long pants must be warn when operating the machine | ||
+ | * Metal chips can be incredibly sharp, do not touch any chips directly instead using an acid brush to remove chips | ||
+ | * Do not inhale any fumes resulting from drilling using oil | ||
+ | * Do NOT wear gloves during operation of machine | ||
+ | * Do not touch tool or spindle until the machine has stopped completely | ||
- | Table Size: | ||
---- | ---- | ||
- | ===== Safety Concerns | + | ===== Training Documentation |
- | Insert Text Here! | + | [[Drill Press SOP]] |
---- | ---- | ||
- | ===== Operating Procedures | + | ===== Detailed Specifications |
- | Insert Text Here! | + | * Spindle Speed Range: 280-3,100 RPM (740-3,100 on main pulley) |
+ | * Quill extension length: 4 3/8" | ||
+ | * Max Drill Bit Diameter:16 mm | ||
+ | * Max Work piece Height: 44" | ||
---- | ---- | ||
+ | |||
===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
Line 47: | Line 51: | ||
- | ===== Training Documentation ===== | ||
- | {{: | ||
- | ---- |
wen_drill_press.1594667212.txt.gz · Last modified: 2020/07/13 19:06 by furst