Differences

This shows you the differences between two versions of the page.

--- ultimaker_3_quick_review [2020/08/18 17:36] – created furst
+++ ultimaker_3_quick_review [2020/08/18 18:48] (current) – [Maintenance] furst
@@ Line 1: / Line 1: @@
-===== Operating Procedures =====
+=====Ultimaker 3 Extended=====
+Tool Lead: Andrew Furst \\
+Contact: Andrewfurst@ucsb.edu
+====Safety Concerns====
+  * Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time.
+  * Keep hands clear of printer during operation. Pause print before clearing or adjusting print.
+ ====Safe Operating Procedures Review====
   - Launch Cura version 4 (blue icon)
   - From connected printers, select IW-Ultimaker3
@@ Line 12: / Line 17: @@
   - Connect thumb drive to printer -> select desired file -> select print\\
 Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired.
+====Post Processing====
+  * If support was constructed from ABS carefully break away with pliers
+  * If support was constructed from PVA soak part in warm water for several hours to dissolve support structure
+====Maintenance====
+  * Bed should be cleaned with IPA between prints
+  * Print heads and silicone head protector should be cleaned as needed
+  * Filament should be dried before use if printer has been idle for several weeks
+  * Bed leveling should be completed every time print cores are swapped
+  * Print cores should be swapped after clog or to change print line width. Used print heads should be kept for spare parts
 -----