Differences

This shows you the differences between two versions of the page.

--- sherline_cnc_mill [2023/01/05 03:50] – [Flashcut / Sherline CNC Mill] haley
+++ sherline_cnc_mill [2024/09/26 19:41] (current) – epace
@@ Line 1: / Line 1: @@
 ====== Flashcut / Sherline CNC Drill ======
-Haley Holcomb 9/12/22
 ^             CNC Diamond Drill                              ^
 |     {{ :tools:sherlinecncmill:sherline_cnc_mill.jpg?nolink&200 |}}    |
 | **Tool Type:**                  CNC                           |
-| **Location:**                   Microfluidics Lab                           |
+| **Location:**                   Elings 3430                          |
@@ Line 11: / Line 10: @@
 | **Manufacturer:**               Sherline                           |
+Last updated 9/12/22 Haley
 ----
 ===== About =====
-CNC diamond drill used to drill holes in glass slides. Uses FlashCut CNC software to interpret G-code and drill holes in programmed locations.
+The Flashcut has been **converted** into part of the crystalmark. If you are curious for more information on this, visit the crystal mark page: [[crystalmark|Crystalmark Etching Tool]]
+The CNC diamond drill is used to drill holes in glass slides. Uses FlashCut CNC software to interpret G-code and drill holes in programmed locations.
 ----
@@ Line 31: / Line 33: @@
 ===== Detailed Specifications =====
-  * Stepper motor mounts and couplers on X-, Y- and Z--axes
+  * Stepper motor mounts and couplers on X-, Y- and Z-axes
   * 70-2800 RPM continuously variable by electronic speed control
   * Maximum CNC travel positioning speed: 22 in/min