Differences

This shows you the differences between two versions of the page.

--- sca_naoh_bath [2023/01/06 00:51] – haley
+++ sca_naoh_bath [2024/09/26 19:51] (current) – epace
@@ Line 4: / Line 4: @@
 |           {{:tools:scanaohbath:scanaohbath.jpg?200|}}        |
 | **Tool Type:**                  Post-processing                           |
-| **Location:**                   Innovation Workshop                          |
+| **Location:**                   Elings 3430                          |
@@ Line 11: / Line 11: @@
 | **Manufacturer:**               PADT                          |
+Last updated 1/5/23 Haley
 ----
@@ Line 16: / Line 17: @@
 This tool is used to dissolve the support filament printed by the Stratysys F270 FDM 3D printer. Parts can be loaded into the main bucket or suspended in a smaller cage during the support removal process.
-----
-===== Detailed Specifications =====
-  * Available Temperatures: 50, 60, 70, 85 degrees C
-  * Auto overfill alarm
-  * 46.3 L tank
 ----
@@ Line 28: / Line 22: @@
 ===== Safety Concerns =====
-This tool makes use of a heated solvent! A lab coat, face shield, and nitrile gloves must be wore by the user whenever the SCA 1200 HT is to be opened to protect for solution and vapor fumes. In case of contact with solution flush eyes, and skin with water, remove all contaminated clothing, and get medical attention immediately. See SDS below.
+This tool makes use of a heated solvent! A lab coat, face shield, and nitrile gloves must be wore by the user whenever the SCA 1200 HT is to be opened to protect from solution and vapor fumes. In case of contact with solution flush eyes, and skin with water, remove all contaminated clothing, and get medical attention immediately.
 ----
@@ Line 35: / Line 30: @@
   - Remove completed part on build tray from F270 3D printer
   - Remove part from build tray, making sure to scrape build tray free of ALL residue
-  - Dawn lab coat, nitrile gloves, and a face shield
+  - Put on a lab coat, nitrile gloves, and a face shield
   - Open lid on SCA 1200 HT
   - Slowly lift large basket, allow time to for excess solution to drip back into SCA 1200HT \\ NOTE: If solution rises above specific level alarm will sound, this is common when lifting or lowering basket and means you're moving too fast!
@@ Line 46: / Line 41: @@
   - Part should be allowed to drip, before being rinsed in sink with plenty of warm water
+----
+===== Detailed Specifications =====
+  * Available Temperatures: 50, 60, 70, 85 degrees C
+  * Auto overfill alarm
+  * 46.3 L tank
@@ Line 55: / Line 54: @@
-===== Reference Documentation =====
-{{:tools:scanaohbath:sca_1200ht_user_manual.pdf|}}
-{{ :wiki:sop_s:sca_1200ht_cleaning_apparatus_solution_change_sop.pdf |}}
-----
+===== Reference Documentation =====
-===== Training Documentation =====
 [[f270_sop|FDM Training SOP]]
+{{:tools:scanaohbath:sca_1200ht_user_manual.pdf|}}
 ----