Differences

This shows you the differences between two versions of the page.

--- rs232_file_transfer_documentation [2022/07/21 21:23] – [RS232 File Transfer Documentation] dave
+++ rs232_file_transfer_documentation [2022/07/21 21:27] (current) – [Troubleshooting/setup check] dave
@@ Line 13: / Line 13: @@
 ====Troubleshooting/setup check====
   - Within the transmission tab in Autodesk HSM Edit select "set up DNC".
-  - Click advanced settings after selecting "machine 1"
+  - Click advanced settings after selecting "Haas"
   - On the Haas select settings (press view/settings once) and using the F2 search command search for "baud" or setting 11 which sets baud rate.
   - Ensure that the DNC settings on the Haas match those selected under "machine 1" on the Haas computer. Keep in mind a different value of baud rate or start/stop codes will cause problems when sending files.
   * Faster Baud rates will result in faster file transfer, however it also greatly increases the chances of errors or failure during transmission. Haas recommends a Baud rate of 9600 with a maximum baud rate of 115.2 kbaud.
+RS232 settings:
+**HSM Edit**
+  * 9600 Baud
+  * Com3
+  * 1 stop bit
+  * 7 data bits
+  * Even parity
+  * Software flow control
+  * DTR enabled
+  * RTS enabled
+  * Check parity box NOT selected
+  * \17 Xon
+  * \19 Xoff
+**Haas (setting 11)**
+  * 9600 Baud
+  * Even parity
+  * 1 stop bit
+  * Xon/Xoff synchronization
+  * 7 Data bits
+  * Leader to punch none
+  * EOB CR LF
+  * Add spaces on
+  * Settings below this do not matter